The following is the construction of Hangzhou Chun How many years of experience to draw anti-static PVC floor performance, for reference: 
 PVC anti-static flooring is PVC resin as the main body is made of a special processing technology, PVC antistatic particles formed between the network interface, a permanent antistatic function. Look like marble, it has good decoration effect. For telecommunications, electronics industry programmed room, computer room, clean room and other requirements of purification and anti-static places. 
 Construction Technology: pvc floor 

 Construction procedure: 
 1, clean up the ground, to find the center line: 
 First, clean up the ground ash residue, and then measuring to find the center of the room, draw the center cross line, cross line required vertical thirds. 
 2, the laying of copper (or aluminum) network: 
 a, on the ground paste the size of the required form a mesh copper bar, copper intersection, the required electrical conductivity of glue to ensure conduction between the copper foil; 
 b, measured with a megger between adjacent copper resistance, its resistance must be less than 105Ω, if any, need to find out why the new barrier paste to ensure conduction between the copper foil; 
 c, paste a good network for each one hundred square meters of copper foil at least four points and ground wire connected. 
 3, the laying of the floor: 
 a, coated with a scraper first part of the ground conductive adhesive; 
 b, to be non-conductive adhesive sticky feel like the case of sticky start laying the floor, laying started from the center to the surrounding block by block to start, side welt beating with a rubber hammer. Maintained between the floor and the floor spacing of 1.5-2.0mm; 
 c, to trowel coating conductive plastic, painted floor, until Puwan the construction of the ground should be 
 d, in the process of laying the floor, must ensure that the next one copper foil on the floor 
 Over 
 e, hot rod with a torch to soften the space between the floor and the floor filled up. 
 f, the rod protruding part of the art knife with a cut to complete the whole way 
 Surface construction 
 g, the construction process, often with megger test whether the surface of the floor between the conduction of the copper foil and, if blocked, must find out the reasons to re-paste, to ensure that each floor of the resistance to ground between the resistance in the 105-108Ω. 
 h, after laying on the floor surface, the surface must be clean. 

 Hangzhou Gongshu epoxy flooring, epoxy flooring, Hangzhou West Lake District, Hangzhou Hi-tech District, epoxy flooring, epoxy flooring, Hangzhou Binjiang District, Hangzhou Xiaoshan District, epoxy flooring, epoxy flooring in Yuhang District of Hangzhou 

 Construction quality requirements: 
 A, the floor surface resistance to ground should be 105-108Ω. 
 B, surface, bubble-free, no shelling phenomenon. 
 C, after completion of construction and clean weld cracks. 
 Maintenance: 
 A, place items on the floor, avoid heavy drag on the floor, wipe the contact surfaces should not be too small, if necessary, block pads available. 
 B, operated on walking on the floor, you can not wear shoes with metal spikes, but can not use sharp objects, hard objects scratch the surface of the floor and percussion. 
 C, often squeezed the wet