Hangzhou Binjiang District, epoxy flooring, epoxy flooring, Hangzhou Xiaoshan District, Hangzhou Yuhang District, epoxy flooring, epoxy flooring, Hangzhou, Fuyang, Hangzhou Lin'an epoxy flooring, epoxy flooring Hangzhou Jun Qiao 

 Jun Qiao solvent epoxy floor coating is a thin coating of epoxy resin colored concrete elements in the good ground, landscaping and renovation, to beautiful effect of dust. 
 The main purpose 
 For computers, electronics, food plants, hospitals, office buildings, general plant, tobacco, textiles, storage, etc. cement or terrazzo. 

 Material Properties 
 Hardening reaction solvent, the surface gloss beauty, low prices. 
 Main raw materials: solvent-based epoxy resin 
 Abrasion Resistance: 15mg (abrasive wheel CS-17, round weight of 1,000 gf {9.8N} 1,000 RPM rotation) 
 Adhesion strength: 230N/cm2 (Newton: international units) 
 Impact resistance: 1Kgw/1mh no cracks, no peeling, no distortion 
 Hardness: 1H-2H 

 Features 
 1. Color, colorful, decorative performance. 
 2. Abrasion resistance, wash, dust, non-slip, excellent performance. 
 3. Coating fullness, color and uniform gloss. 
 4. Topcoat can be brush, roller, spray and other construction methods. 

 Hangzhou Binjiang District, epoxy flooring, epoxy flooring, Hangzhou Xiaoshan District, Hangzhou Yuhang District, epoxy flooring, epoxy flooring, Hangzhou, Fuyang, Hangzhou Lin'an epoxy flooring, epoxy flooring Hangzhou Jun Qiao 

 Construction Method 
 Jun construction method in coating a clever floor epoxy primer surface coating using the following method: 
 1. Primer Coating: Mix first Group A points, and press A, B ratio were prepared; Stir to scrape plates or roller construction. 
 2. In the coated coating: the primer is dry, use a spatula to be painted again in the coating batches to fill the holes in the floor. Completely dry, you can scratch two times in the coating in order to increase the coating thickness, increased stress resistance. 
 3. Until the coating is completely dry, the use of grinder, sandpaper and so polished, that will be awarded marks produced by James, not smooth polished off place and the particles, and dust with a vacuum cleaner. 
 4. Roll finish: The finish in proportion to the deployment is completed, the floor with a roll coating method will even roll over (also used spray brush), roll a second time if necessary to finish, the same way. 
 5. Stir the protective agent to cotton or cotton mop coating. Required uniform, no residue. At the same time there are sharp objects should be careful not to scratch the surface.